Clamp Tool for Stainless Steel Band

All Well strapping tape made of C201 stainless steel have a bright finish with fully rounded edges, excellent tensile properties, good resistance to oxidation and corrosive agents, which allows their use in environments where high resistance to corrosion is required, to fix pipes, cables, etc.

The clamp tool is for cutting SS band strap.


  Jetzt Kontakt aufnehmen
Produktdetails

Our clamp tool for SS banding strap with the advantages below: 

1.It has a wide range of applications and multiple uses. It can be used to bundle cables, pipes, signs, brackets, etc. 

2.As a packing tool, it saves time and effort, is convenient to tighten, the card slot is fixed, and it is easy to cut. 

3.Comfortable handle, easy to operate, thick plastic powder, wear-resistant, suitable for complex operating environment. 

4.Die design, sturdy and durable. Forged with high-strength tool steel, strong and durable. 

5.Simple operation and convenient installation. Excellent selection of materials, strong binding force, tight shrinkage, and simple operation.

Clamp Tool for Stainless Steel Band

Clamp Tool for Stainless Steel Band

Clamp Tool for Stainless Steel Band

Clamp Tool for Stainless Steel Band

Using steps:

Clamp Tool for Stainless Steel Band

Clamp Tool for Stainless Steel Band

Installation steps: 

1.According to the actual use, cut a certain length of stainless steel cable tie, thread the buckle to one end of the tape, and reserve a length of about 5cm(Cutting length = the required length of the bundle+5cm+10cm).

2.Bend the reserved tape to preliminarily fix the stainless steel buckle. 

3.When strapping, wear the other end of the stainless steel tape, and reserve a length of at least about 10cm for the strap tightening machine to pull into the tape.

4.clamping the tape with a tightening machine, and start to shake the rocker arm to slowly pull in the tape. Make sure that the tape is just tightened. Do not tighten the tape too much to avoid damage the tool.

5.When the tape is tightened, fold back the entire strap tightening machine and cut the tape by turning the blade handle. 

6. Knock the two corners of the buckle flat with a hammer to block the final tape head to complete the binding process.



Send your message to us